Threaded Rod Cutter

Copyright © 2008 [M&S Valves & Fittings].

 All rights reserved. Send all mail request to [msvalves@aol.com]
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks

or registered trademarks of their respective companies or mark holders.
Last modified: May 29, 2008

Back

• Precise clean cut on 3/8" UNC threaded rod
• Unique die design protects the threaded rod from damage after cutting
• No deburring required after cutting and before screwing on nuts
• A clean cut every time, just screw the hex nut on the cut end
• Reversible dies (No. 1270501) provide approximately 600 cuts per side
• Mounting holes on base for permanent mounting to work surface
• For use on construction sites where threded rod is used to secure pipe, conduit sprinkler systems, duct work, lighting and many other components