REMS Curvo®
|
Universal,compact electric tool for cold bending of pipes and tubes up to180º.Can be used anywhere, without vice.For workshop, job site, repair. |
|
|
Hard, half-hard, soft copper tubes also thin-wall |
Ø10-35mm |
|
Ø 3/8-1 3/8" |
|
|
Coated soft copper tubes, also thin-wall |
Ø 10-18 mm |
|
Stainless steel tubes of pressfitting systems |
Ø 12-28 mm |
|
Coated steel tubes of pressfitting system mapress C-STAHL |
Ø 12-28 mm |
|
Soft precision steel tubes |
Ø 10-30 mm |
|
Steel pipes DIN 2440 |
Ø 1/4-3/4" |
|
Electric conduit DIN EN 50086 |
Ø 16-32 mm |
|
Multi-layer composite tubes |
Ø 14-40 mm |
REMS Curvo- wrinkle fee bending. Universal for many pipes and tubes. Instant use without
setting. Fast creep speed operation for precise bending. Rapid change of bending and back formers.
Univerasl Use-
For sanitary, heating, air conditioning,refridgerating and hydraulic applications. Speciallysuited for tubes
of pressfitting systems, for hard and half-hard copper tubes and for thin-walled copper heating tubes
according to DIN EN 1057.
System Advantage-
Only one type of bending and back formers for REMS Curvo and REMS Sinus. Therefore simple,
inexpensive stocking. No confusion possible.
Cost Advantage-
Bender cost recovered after a small number of bends. No cost for fittings, storage, procurement.
Savings in soldering joints, pressing joints and working hours. Higher safety thanks to fewer pipe joints.
Execution-
Compact, handy electric tool with intgral absortion of torque during bending. Super light, drive unit
only 8 kg. Can be used anywhere, anytime. No setting. Simple, effortless, fast working, e.g. 90º bends,
Ø 22 mm in only 6 s. Fast and creep speed operation for precise bending. Crossover, swan-neck,
U-bends possible. Height adjustible machine support as accessory.
Bending Formers and Back Formers-
Form and pressure resistant, in high-strength, high-slide, glass-fibre reinforced polyamide.
Optimum mating of bending formers and back formers ensures sliding appropriate to the material
without cracks and wrinkles. Angle scale 0 to 180º provided on each bending former and mark on the
back former ensure precise bending , Rapid change of of bending fromers and back fromers. Bending
formers and back formers for different sizes, materials and bending radii, see table lower on page.
Drive-
Robust, maintenance-free gear. Final point safety in both directions throught safty slipping clutch.Proven,
powerful universal motor, 1000W. Right and left-hand rotation. Stepless electronic safty switch for rapid
and creep speed operation.
Bending Lubricant-
REMS bending spray ensures a permantent lubricating film for reducing energy expenditure and uniform
bending. High-pressure-proof, acid-free. CFC-free, so ozone-harmless.
Supply Format-