Non Pressure Joint Repair Kit - applied with pressure removed.

Copyright © 2008 [M&S Valves & Fittings].

 All rights reserved. Send all mail request to [msvalves@aol.com]
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks

or registered trademarks of their respective companies or mark holders.
Last modified: May 29, 2008

Back

Contents: Syntho-Glass and Liquid Epoxy Resin

• Product Summary
• Key Features

Product Summary Like other Syntho-Glass Pipe Repair Kits, Our joint repair kit is available to service three size ranges of pipe and will work on all types on piping material. This kit includes a no mess easy mix self contained 2 part liquid epoxy resin and catalyst. Simply remove the separator clip dividing the two parts and mix by kneading the plastic pouch until resin is uniform in color. Put on enclosed gloves before opening the resin pouch. With pipe pressure removed, pour resin catalyst mixture of uniform color over the area of the joint that was leaking before the pressure was removed. Open the foil pouch, remove the Syntho-Glass Fiber Glass Casting like Cloth Wrap and soak in water. After 30 seconds remove the wrap from the water and over wrap the area you applied the resin. Repair will set rock hard in 20 to 40 minutes depending on the ambient temperature in the air.

Key Features

• No Measuring

  - liquid resin and catalyst mixture, comes pre-measured for an accurate mix.

• No Mess

  - self contained plastic pouch with simple divider clip for clean and easy mixing.

Saves Time and Expense of Replacement!

This joint repair kit will save you time versus draining a sprinkler system and replacing the joint. Simply turn off the pressure and apply this repair kit and in minutes you will be back in business!

Non Pressure Repair Kits for

Joints, Tees, and Couplings